73-79 dash conversion ?
Moderator: FORDification
-
tybob81
- Blue Oval Fanatic
- Posts: 840
- Joined: Thu Mar 23, 2006 2:53 am
- Location: Murphysboro IL
- Contact:
re: 73-79 dash conversion ?
If you open the holes out a little you should be able to put autometer gauges in. When I had my round cluster I did not have the means of a tool or mill to open up the holes were they would look good. So I sold it to a guy wanting to use the factory round gauges and used that money to but my billet insert. If there is a will there is a way, so figure out a way to mount them and you'll be set.
1968 swb hydroboost, ididit tilt column, Saginaw p/s pump with F series serpentine, all led lights, Vintage Air and painless wiring. 393w, tko600. CV front suspension w/c5 calipers and gt500 rotors. Stock Flexomatic leaf springs with 01 CV 8.8, 3.90 gears and Auburn locker. Custom wood bed floor. Full frame off resto-mod.
-
wt4speed#2
- Blue Oval Guru
- Posts: 1064
- Joined: Fri Mar 25, 2005 9:21 pm
- Location: Texas, Ft. Worth
-
fitzwell
- Blue Oval Fanatic
- Posts: 779
- Joined: Wed May 10, 2006 2:16 pm
- Location: East of a rock, west of a hard place
done.....you gonna be around tonight?wt4speed#2 wrote:Hey fitz
I got one in the garage , F-600 gauge panel ,that is. You should come by and check it out.
As a metter of fact, i AM trying to keep up with the Jones'
Driving like Parnelli, Drinkin' like George
-------------------------------------------------------
Driving like Parnelli, Drinkin' like George
-------------------------------------------------------
-
wt4speed#2
- Blue Oval Guru
- Posts: 1064
- Joined: Fri Mar 25, 2005 9:21 pm
- Location: Texas, Ft. Worth