F-500 Instrument Panel RPM Gauge Question
Moderator: FORDification
-
cghstrojan08
- Blue Oval Fan
- Posts: 562
- Joined: Sun Jan 01, 2006 7:28 pm
- Location: Toledo, OH
F-500 Instrument Panel RPM Gauge Question
What is a good rpm gauge the will fit into the F-500 instrument panel? Would a hole-saw work to cut the hole out?
ROBERT
Member #1076
1968 F100 SWB 360
1969 F100 LWB 360 "Ol' Blue" - Sold
1976 F350 Trailer Special, Extended Wheel base, 460
http://s9.photobucket.com/albums/a75/cg ... ld%20Blue/
Member #1076
1968 F100 SWB 360
1969 F100 LWB 360 "Ol' Blue" - Sold
1976 F350 Trailer Special, Extended Wheel base, 460
http://s9.photobucket.com/albums/a75/cg ... ld%20Blue/
-
mrsnicks
- Blue Oval Fan
- Posts: 728
- Joined: Sun Feb 19, 2006 11:02 pm
- Location: North Carolina, Cameron
The smaller Sun tachs, or a Stewart Warner will work, and yes, a hole saw should work.
Patrick
Patrick
Chevrolet
Can Hear Every Valve Rattle on Long Extended Trips
1969 F100 4X4 Highboy 390 3sp
1969 F100 SWB 2wd Auto 351w
1972 F100 Ranger XLT 302 Auto
http://mrsnicks.blogspot.com
http://www.fordification.com/galleries/ ... ?cat=10336
Can Hear Every Valve Rattle on Long Extended Trips
1969 F100 4X4 Highboy 390 3sp
1969 F100 SWB 2wd Auto 351w
1972 F100 Ranger XLT 302 Auto
http://mrsnicks.blogspot.com
http://www.fordification.com/galleries/ ... ?cat=10336
-
Redcap
- Blue Oval Fanatic
- Posts: 947
- Joined: Mon Dec 20, 2004 10:29 pm
- Location: Washington, Centralia
- Contact:
re: F-500 Instrument Panel RPM Gauge Question
Hole saws work fine, just clamp the F600 panel down to something you don't mind cutting into and start a pilot hole.
