Need trouble shooting advice
Moderators: FORDification, Thunderfoot
- FLATBEDFORD
- 100% FORDified!
- Posts: 1818
- Joined: Sat Feb 18, 2006 1:34 pm
- Location: New York, Crugers
- Contact:
Need trouble shooting advice
Sorry about the non-specific title. My '70 F350 platform/stake has one of those back-up beepers. It seems to get it's power from the driver's side back-up light. With lights on the beeper gets very quiet. If I put my foot on the brake and the headlights are on it stops. It seems to work OK with the brake lights and no headlights. With no other lights, it works fine. The back-up lights still light up with or without the other lights on. I haven't looked very deeply into this. I don't know where to start. Maybe the beeper needs a better ground? Could the other lights be messing it up through some kind of ground leak? My limited electrical knowledge leaves me stumped.
Steve
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
- 71PA_Highboy
- Blue Oval Fanatic
- Posts: 923
- Joined: Tue May 23, 2006 11:32 am
- Location: Denver of the East
re: Need trouble shooting advice
OK... check and recheck EVERY ground connection... then verify them.
Make sure you have a good ground between body, engine and frame.
From what I read about your issue, this will eliminate your problem...
hth,
eric
Make sure you have a good ground between body, engine and frame.
From what I read about your issue, this will eliminate your problem...
hth,
eric
Got Ford?
2 EarlyBroncos (68,69)
2 Classic Mustangs (69,70)
1 F250 4x4 (71) - OB - 360, NP435, D24, HPD60 4.10, D60,
1 94 Ranger, 2.3, 5spd
1 Lincoln Mark VIII
2 EarlyBroncos (68,69)
2 Classic Mustangs (69,70)
1 F250 4x4 (71) - OB - 360, NP435, D24, HPD60 4.10, D60,
1 94 Ranger, 2.3, 5spd
1 Lincoln Mark VIII
- FLATBEDFORD
- 100% FORDified!
- Posts: 1818
- Joined: Sat Feb 18, 2006 1:34 pm
- Location: New York, Crugers
- Contact:
I figured its a ground issue. What doesn't make sense is that only the stupid beeper has a problem and the lights are unaffected. I'll start with beeper's ground and work from there. The wiring, except the beeper, appears to be original and unmolested.
Steve
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
- ToughOldFord
- 100% FORDified!
- Posts: 1911
- Joined: Mon Jul 25, 2005 10:47 pm
- Location: Communist California, USA
re: Need trouble shooting advice
Yep, I vote for the beeper's ground too.
- 71 LONG BED
- 100% FORDified!
- Posts: 1588
- Joined: Wed Jun 14, 2006 7:28 am
- Location: Hamburg, NJ
re: Need trouble shooting advice
You might even want to replace the wiring for the beeper. I might appear to be intact, but it may be completely corroded inside the insulation. Therefore, not getting good conductivity. Just a thought. I just replaced all the wires for all the lights on the whole back half of the dump truck.
John Member #1549
71 F100 Sport Custom__________1967 F350 Gone, but not forgotten
71 F100 Sport Custom__________1967 F350 Gone, but not forgotten
- FLATBEDFORD
- 100% FORDified!
- Posts: 1818
- Joined: Sat Feb 18, 2006 1:34 pm
- Location: New York, Crugers
- Contact:
You're not neglecting the F100 are you? It's tuff having two isn't it? My '96 has suffered since I got the '70.
Steve
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
- FLATBEDFORD
- 100% FORDified!
- Posts: 1818
- Joined: Sat Feb 18, 2006 1:34 pm
- Location: New York, Crugers
- Contact:
I think I know what you meankid wrote:LOl yep fixing the daily Driver weekly lowers the down for maintenance to one to Quarterly.
Steve
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/
1970 F350 DRW Factory 9' Platform/Stake, 360, T18.
Passed on to new care taker July, 2013
My Photo Gallery
http://s115.photobucket.com/albums/n298/flatbedford/