back-up light switch

Charging, starting, lighting, gauges, HVAC

Moderators: FORDification, Thunderfoot

Post Reply
burntorangeandwhite
New Member
New Member
Posts: 12
Joined: Sun Jan 20, 2008 3:43 pm

back-up light switch

Post by burntorangeandwhite »

The wiring harness on my 1970 F250 looks like its been messed with at least a couple times. The back-up light turns on and stays on as soon as I turn on the electrics. I traced the wire from both back-lights to under the dash but it looks like it was connected to some other wire I have not been able to trace-on (which does not correspond to the diagram). Anybody know where the the back-up light switch is located on the truck, i.e. where ultimately the wiring should end?

Thanks!
User avatar
FORDification
Site & Forum Admin
Site & Forum Admin
Posts: 8050
Joined: Sun Jul 11, 2004 12:52 am
Location: Kansas, Wellsville
Contact:

Re: back-up light switch

Post by FORDification »

Depends on what transmission you've got. If you've got an automatic, then the back-up light switch is built into the neutral safety switch, which is located at the base of the steering column inside the cab.

Image

If you've got a three-speed manual with column shift, it'll be the switch at the very end of the column in the engine bay:

Image
(Sorry for the bad pic, it's the only one I have on hand right now.)

If you've got a 4-speed, then the back-up light switch is mounted on top of the gearshift cover:

Image
____| \__
-O-----O- Keith
'67 F-100 2WD SWB ~ '69 F-100 4WD SWB w/7" chop ~ 1975 F-250 Ranger XLT Supercab Camper Special
ImageImageImage
My '67 restoration video
-> Posting and you! <-a MUST watch for all!!
burntorangeandwhite
New Member
New Member
Posts: 12
Joined: Sun Jan 20, 2008 3:43 pm

Re: back-up light switch

Post by burntorangeandwhite »

Thanks for the response! I have a 3 speed automatic - so I'll check the location you mentioned for that case.
User avatar
Lar4t9r
New Member
New Member
Posts: 117
Joined: Fri Sep 28, 2007 9:35 am
Location: Ocala, Florida

Re: back-up light switch

Post by Lar4t9r »

If you don't mind, may I hijack this thread?
I have a C4 transmission in my '69 f100 that PO converted from column to a B & M floor shifter. He did not make any provision for backup switch or neutral safety switch. I want to add these but have not found any info on how to do it with this setup. :hmm:
Any advice?
Laurence (Proud owner of 1969 Ford F-100 and 1970 GTO)
ImageImageImage
fordman
100% FORDified!
100% FORDified!
Posts: 22329
Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:

Re: back-up light switch

Post by fordman »

the dentside trucks had athe nss on the transmission. you might be able to find one of those and put it on your transmission.
User avatar
Lar4t9r
New Member
New Member
Posts: 117
Joined: Fri Sep 28, 2007 9:35 am
Location: Ocala, Florida

Re: back-up light switch

Post by Lar4t9r »

fordman wrote:the dentside trucks had athe nss on the transmission. you might be able to find one of those and put it on your transmission.
Well, I have been searching for this, but all I can find that mount on the transmission are for manual, not automatic. All the automatics I've found mount on the column. Anybody happen to know a sorce for a transmission mounted switch for C4 automatic?
Laurence (Proud owner of 1969 Ford F-100 and 1970 GTO)
ImageImageImage
fordman
100% FORDified!
100% FORDified!
Posts: 22329
Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:

Re: back-up light switch

Post by fordman »

i had a 78 that had that switch on it. the transmission was a smallblock c6. all o fth ecolumns i have taken out of dentsides up to 78 have had the column nss on them. i would check with the vendors abotu a nss for 78 and 79 trucks and broncos. they aslo used that switch on cars. i don't know which cars or what year of cars.
User avatar
Thunderfoot
100% FORDified!
100% FORDified!
Posts: 2207
Joined: Tue Apr 17, 2007 2:34 pm
Location: Idaho, Boise

Re: back-up light switch

Post by Thunderfoot »

For a C4 look for one for a Mustang! My 68 stang has the switch on the transmission. :thup: here is a link to Mustangs Unlimited showing the Neutral Safety Switches... http://www.mustangsunlimited.com/keywor ... &x=13&y=13 these will have the 4 wires on them for the reverse and neutral wires so you can wire it into your trucks wiring with no problem. :)
Shayne
I'm not "Brand Loyal" Ford-Chevy-Dodge-Toyota I have them all, one even cross mixed...
If it Looks good and Works good then it's ok by me. Everything has its issues from time to time...

69 SWB (project) & 69 Highboy (driver/project)
http://s197.photobucket.com/albums/aa29 ... d%20truck/
http://www.fordification.com/galleries/ ... ?cat=10399
User avatar
Lar4t9r
New Member
New Member
Posts: 117
Joined: Fri Sep 28, 2007 9:35 am
Location: Ocala, Florida

Re: back-up light switch

Post by Lar4t9r »

Thanks, guys...That should work.
Laurence (Proud owner of 1969 Ford F-100 and 1970 GTO)
ImageImageImage
fordman
100% FORDified!
100% FORDified!
Posts: 22329
Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:

Re: back-up light switch

Post by fordman »

or for just a reverse light you coul dmake a bracket that is close enought to where the lever kicks in a switch when you put it in reverse.
User avatar
Lar4t9r
New Member
New Member
Posts: 117
Joined: Fri Sep 28, 2007 9:35 am
Location: Ocala, Florida

Re: back-up light switch

Post by Lar4t9r »

fordman wrote:or for just a reverse light you coul dmake a bracket that is close enought to where the lever kicks in a switch when you put it in reverse.
I am concerned about the safety of not having the NSS...so want to have both backup light switch and NSS.
Laurence (Proud owner of 1969 Ford F-100 and 1970 GTO)
ImageImageImage
Post Reply