Which ignition is this for?

[Old Bird]

Does someone know if this plug will fit a late 70-72 ignition? Can someone look for me if you don't know off hand?

The PO put a Ron Francis wiring harness in and this is the plug for the ignition. I was foolish and didn't look before I ordered a new ignition switch and got the one with round connectors. I would rather not splice the wires if I don't have to, and the ignition he put in there doesn't fit (it looks like it's a switch from a trailer or something, not a truck). If this is right for the later model ones I'll get the later switch.

[fordman]

i don't think so that isnt right for our switches.heres a quick pic at this time of night. the blade switches have the blades going in several different directions. that plug wont fit onto the stock switches.

[Old Bird]

Thanks for getting that picture for me. I guess I'll have to get the plug and splice wires. At least the Ron Francis wires are labeled.

[68f100ranger]

you shouldnt have to cut the wires on your new harness, you can just pull the metal connectors out of a plug to repair them or whatever. Ive pulled plugs apart before to change the plugs or replace a bad connection. There is just a little tang on the back of the connector that locks into the plug, if you have a small screwdriver or something small and flat you can release that tang and pull the connector(s) out.

[Old Bird]

Thanks, for now I've decided just to leave it. It works, and that's good enough for the time being.