Installing A New Turn Signal Switch

[derek7871]

How hard is it going to be to hook up all the wiring on a new turn signal switch? I'm quite sure the switch is bad and I've put off changing it for a while. That big mess of wires on the new switch is kind of intimidating. Do they all end up at the same location and you just have to make sure you hook them up correctly?

Cooter

[fordman]

the wires go down through the trough insid eof the column. when you pull the old wires out tie a string or soemthing to them so you can pull the new ones back through. you will have to remove the pins from the connector and plot thier location in the plug to put the new wires back into that plug.

[derek7871]

Ah, a string. That would make it a lot easier to get the new wires down through the column. Thanks, Fordman. Seems like I remember a picture on here that shows which color wire goes where. Off to search.....

Cooter

[fordman]

try this for your search http://www.fordification.com/wiring.htm