What board do they use for the backing of the fabric door panels?
Also how can I remove the trim I have without tearing up the trim?
Door panel question
Moderator: FORDification
-
OldRedFord
- Blue Oval Guru
- Posts: 1314
- Joined: Tue Jan 29, 2008 11:37 pm
- Location: Hull GA
- Contact:
Door panel question
You do not have the required permissions to view the files attached to this post.
Tim
1972 F350 flatbed drw c6/390
1967 F600 project truck
1972 F350 flatbed drw c6/390
1967 F600 project truck
-
Joe Kriston
- Blue Oval Fan
- Posts: 740
- Joined: Fri Feb 18, 2005 11:37 pm
- Location: Arizona, Phoenix
Re: Door panel question
To remove the door panel from the door, use the tool on the right...The tool on the left is a staple puller....Start by removing the staples from the backboard, then hopefully, the vinyl will become unglued, rather than you...
I used that 1/8 inch masonite for mine---the stuff that's smooth on one side and waffled on the other, but I'm not sure I'd recommend it---it's a little thick...
You do not have the required permissions to view the files attached to this post.
This is the point...I'm....talking about everybody! I'm talking about form! I'm talking about content! I'm talking about interrelationships! I'm talking about God, the devil, hell, heaven!!!! Do you understand???? Finally!!!!
-
OldRedFord
- Blue Oval Guru
- Posts: 1314
- Joined: Tue Jan 29, 2008 11:37 pm
- Location: Hull GA
- Contact:
Re: Door panel question
How did it look with the 1/8 inch? Or is it just hard to work with?
Tim
1972 F350 flatbed drw c6/390
1967 F600 project truck
1972 F350 flatbed drw c6/390
1967 F600 project truck
-
fordman
- 100% FORDified!
- Posts: 22329
- Joined: Sun Aug 28, 2005 8:17 pm
- Location: Kansas, Ottawa
- Contact: