Inside the cab...appearance, repair, upgrades
Moderator: FORDification
austin
Blue Oval Fan
Posts: 572 Joined: Mon May 04, 2009 11:30 pm
Location: Utah, Moroni
Post
by austin » Wed Nov 25, 2009 11:17 pm
does anyone know if the door seal plates came stock on all bumps?
my dad seems to think they did and i have no clue
1971ford
100% FORDified!
Posts: 5565 Joined: Wed Jul 04, 2007 1:05 pm
Location: Placerville CA
Post
by 1971ford » Wed Nov 25, 2009 11:39 pm
the aluminum plates that run along the weatherstripping, that also hold the carpet down? Yes those are on all bumps.
-Ryan
fordman
100% FORDified!
Posts: 22329 Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:
Post
by fordman » Thu Nov 26, 2009 1:12 am
yes they came on all trucks. to hold down the carpet or mat. plus they aslo hold the door rubber ends on. that is where they meet is under the sill plate.
austin
Blue Oval Fan
Posts: 572 Joined: Mon May 04, 2009 11:30 pm
Location: Utah, Moroni
Post
by austin » Thu Nov 26, 2009 2:45 am
yup those are the plates im talking about mine are missing and a big chunck of weatherstripping is gone to i guess i will look for some new ones and some new weatherstripping too
thank you
flyboy2610
100% FORDified!
Posts: 4901 Joined: Sun Oct 03, 2004 6:42 pm
Location: Nebraska, Lincoln
Post
by flyboy2610 » Thu Nov 26, 2009 11:24 am
LMC has them. That's where I got mine, and they fit just fine.
austin
Blue Oval Fan
Posts: 572 Joined: Mon May 04, 2009 11:30 pm
Location: Utah, Moroni
Post
by austin » Sat Nov 28, 2009 1:31 am
okay would dent side sill plates fit? i have a set out my 73
fordman
100% FORDified!
Posts: 22329 Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:
Post
by fordman » Sat Nov 28, 2009 4:13 am
yes they will fit. the only real difference is where they come up the kick panel. the dentside ones dont go up as far as are do. so the screw hole in hte kick panel will still be showing if you use the dentside plates.
austin
Blue Oval Fan
Posts: 572 Joined: Mon May 04, 2009 11:30 pm
Location: Utah, Moroni
Post
by austin » Sat Nov 28, 2009 11:01 am
thank you i will have to pull them plates
austin
Blue Oval Fan
Posts: 572 Joined: Mon May 04, 2009 11:30 pm
Location: Utah, Moroni
Post
by austin » Sat Nov 28, 2009 2:20 pm
pulled the plates they fit perfect i going to polish them up a bit and install them for good