Custom Transmission Crossmember Build

Clutch, transmission, rear axle

Moderators: FORDification, 70_F100

Post Reply
Aerocoupe
New Member
New Member
Posts: 119
Joined: Wed Aug 12, 2015 3:02 pm
Location: Jenks, OK

Custom Transmission Crossmember Build

Post by Aerocoupe »

Will be putting a Coyote and 6R80 in my F100 at some point (getting one through college so priorities are on that) and I was contemplating how to build the trans cross member. I always like the looks of a round tube cross member but was having a hard time figuring out how to make the tubular ends with urethane bushings. After a lot of searching I ran across this article and just had to share with the forum as it simple and very effective.

http://www.how-to-build-hotrods.com/cus ... ounts.html

Has anyone done anything similar?
cep62
100% FORDified!
100% FORDified!
Posts: 2061
Joined: Sun Oct 26, 2008 8:06 pm
Location: West Michigan

Re: Custom Transmission Crossmember Build

Post by cep62 »

That's an interesting link , thank you for sharing
Post Reply