'69 overhaul- CV, 8.8, and more.

Post progress reports on your project truck(s)

Moderator: FORDification

Post Reply
User avatar
Manny
Blue Oval Guru
Blue Oval Guru
Posts: 1190
Joined: Wed Oct 04, 2006 7:15 pm
Location: Georgia, Lake City
Contact:

Re: '69 overhaul- CV, 8.8, and more.

Post by Manny »

Definitely enjoying your fab work here. Anything else to report? :? :thup:
Just another Ford fool named Dan.
The Junk that hangs around
67' F-250 highboy Camper special cross breed currently under way
http://www.fordification.com/forum/view ... 22&t=86706
1974 Bronco 302 3 speed
1984 bronco 302 c6 35's
1994 F350 7.3 5spd dually.
woods wrote: The rust holes in my truck were a factory install (very rare).
rms
New Member
New Member
Posts: 50
Joined: Sun Aug 23, 2015 1:50 pm
Location: North Atlanta

Re: '69 overhaul- CV, 8.8, and more.

Post by rms »

Manny wrote:Definitely enjoying your fab work here. Anything else to report? :? :thup:
Thanks! I hope to report driving it soon; it’s real close. Just need to put the bed on and wire the taillights.
-Ryan
1969 F100
Lowell
New Member
New Member
Posts: 25
Joined: Wed Jul 23, 2014 2:49 pm

Re: '69 overhaul- CV, 8.8, and more.

Post by Lowell »

I am interested in hearing yours and other's take on the exhaust exiting where is does, in front of the rear axle. I have considered doing the same, but have heard and read some negatives on it. Mainly dirtying up the undercarriage and blowing dirt/dust from road surfaces. I am really interested in doing my exhaust this way, especially after seeing it done on a 56 F100.
rms
New Member
New Member
Posts: 50
Joined: Sun Aug 23, 2015 1:50 pm
Location: North Atlanta

Re: '69 overhaul- CV, 8.8, and more.

Post by rms »

Lowell,
I have had turn down exhaust on all my hot rods for 20+ years. I haven’t noticed any negatives, but it is louder and drones more.


Today I put the bed back on. I also torqued down all the suspension, set the preload on the Cal-tracs and did a quick home alignment with my Longacre kit.

Image
-Ryan
1969 F100
Post Reply