

That dark-colored patch on the left side is where the sheetmetal got rust-pitted where the paint wore off. I'm planning on sandblasting that area to get rid of all rust, sand it back down, and then a couple coats of primer/surfacer should smooth it right out. However, the lower rear corner on that side is going to take a little hammer and dolly work. It was beat up by the previous owner, who apparently gave a half-hearted attempt at straightening it out and then covered it with filler. It'll take at least an afternoon or two to smooth it out a little more. It's not really that bad:

I'll be in the shop again on Sunday to get some more work done on this.
