What did you do to YOUR bump today?

big orange · Post by **big orange** » Wed Dec 02, 2009 2:38 pm

Here ya go

HillbillyDelux · Post by **HillbillyDelux** » Wed Dec 02, 2009 9:04 pm

i like that a lot

big orange · Post by **big orange** » Wed Dec 02, 2009 9:51 pm

Thanks!!

72_Shorty · Post by **72_Shorty** » Wed Dec 02, 2009 10:00 pm

Took off the front wheels to check the brake wear, and decided to sell it. I'll get another one someday when i have the time and money and space to tinker with it as much as I like to. It's a 72 F-100 swb with 390 GT and C-6 trans. It's listed in the classified forums on here.

rjewkes · Post by **rjewkes** » Wed Dec 02, 2009 11:54 pm

Dialed in the carb from ultra lean to just about right.

fordman · Post by **fordman** » Wed Dec 02, 2009 11:56 pm

does it count? if you think about working on your truck?

rjewkes · Post by **rjewkes** » Wed Dec 02, 2009 11:58 pm

!/2 a point Craig. You did atleast think about it

wildcard · Post by **wildcard** » Thu Dec 03, 2009 7:25 pm

Actually it was last night. I had to install a new floor shifter. Now I don't have to search for 2nd and 3rd anymore.

GSequoia · Post by **GSequoia** » Fri Dec 04, 2009 3:56 pm

72_Shorty wrote:Took off the front wheels to check the brake wear, and decided to sell it. I'll get another one someday when i have the time and money and space to tinker with it as much as I like to. It's a 72 F-100 swb with 390 GT and C-6 trans. It's listed in the classified forums on here.

Getting a new truck is quite a way to do a brake job!

GSequoia · Post by **GSequoia** » Fri Dec 04, 2009 3:57 pm

fordman wrote:does it count? if you think about working on your truck?

Hell if that counts I've restored mine about four or five times over and built a 4x4 long bed crew with a CTD and six speed! (I spend between 45 minutes to an hour each way to go to/from work, I get a lot of thinking time!)

1971ford · Post by **1971ford** » Fri Dec 04, 2009 10:34 pm

I swapped my Baja wheels for my Blades. I like them better

I also hooked my dome light back up, and i drove it around the court of course

papabug71 · Post by **papabug71** » Fri Dec 04, 2009 11:13 pm

Im installing a copper oil line for my oil press. gauge. The old plastic line started leaking, so its time to go. Its been on since '95 so all n all it held up pretty good.

Im pulling an all nighter in the shop. I function better at night.

big orange · Post by **big orange** » Fri Dec 04, 2009 11:13 pm

Looked at her in the garage ... then open the fridge and grabed a beer

ToughOldFord · Post by **ToughOldFord** » Fri Dec 04, 2009 11:45 pm

I parked her behind the fence.

That's the routine, I use the '07 most of the time, but occasionally I feel like driving a Real Truck so I fill the '69 and drive it for a week. If all I do is drive to work and back I can go a week on a tank. Then it's back to the F150.

rjewkes · Post by **rjewkes** » Sat Dec 05, 2009 10:20 pm

Fixed a blown lower rad hose.

The FORDification.com Forums

What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?

Re: What did you do to YOUR bump today?