What did you do to YOUR bump today?

[91Bear]

I put a loveseat in it and hauled it to downtown San Antonio for my wife. When I got there, I had lost a hubcap. Not a huge deal, but it irks me.

[1970FordTK]

Waiting on the exhaust manifold to come in to replace the one that cracked over the long cold spell. Thank goodness I used my anti seizure on the bolts, just my luck to get a cast iron piece with a defect and have it show up a year past the warranty. On a good note, gasket and doughnut where in ace shape and didn't leave hardly any stuff to scrape off. New manifold is coming with both a new gasket and doughnut, just have to warm up an area to paint it.

[FordTruck]

Pushed my 70 back off of the side of the house to start the hunt for another flywheel cuase I'm itchin to drive it again. Also thought about putting a 91 EFI 302 out of a bronco in my Camper Special.

[indytexan929]

I did this yesterday, just slow in posting. I replaced the vent window frame on the drivers side door. Actually wasn't that hard! I have the instrument panel out right now and doing some work on it. I'll paint the needles, replace the clear plastic piece (yellowed), and I am swapping the bezel from my '68 to one I pulled out of a '71. Mine is open in the middle, and the '71 has the bar in the middle. It was a little scratched, so I have lightly sanded it and am repainting it with some silver Rustoleum Hammered paint. It gave it a cool texured effect. I will paint the proper places black after the silver dries and cures. I have also repainted the inside of the metal shield just inside the plastic with black Hammered Rustoleum on the outside, and white in the inside. I'm hoping the white in the inside will reflect the light onto the gauges better. I'll have pics up later!

[FordTruck]

Got a free F600 instrument cluster for my 70.

[Caseys71]

So far over the last day or so I've taken off the bed, stripped most of the interior and removed about 3/4 of the front clip , Now the neighbors are starting to see the project part of my project .

[GSequoia]

Parked it in the driveway so the street sweeper can do his job (it normally lives on the street).

[no_treble]

.
.
Pulled the feisty little 302 out.

[austin]

got my speedometer working and tryed getting it to run better and deiced i need a cap and rotor (the only things i havent replaced )

[1970FordTK]

Put the RH exhaust maifold on (new one, and not made in china either) truck is now back to being quiet up front execpt now I can hear a very, very small dought exhaust leak from the drivers side. That I'm going to live with till it drives me nuts and I have to fix it.

[91Bear]

I put a loveseat in it and hauled it to downtown San Antonio for my wife. When I got there, I had lost a hubcap. Not a huge deal, but it irks me.

Heh, I found the hubcap on the left shoulder of I-10 here in San Antonio. I pulled the car over, ran out and grabbed it. I'm really glad I didn't get hit. I didn't want my wife to inscribe on my tombstone "He died trying to retrieve a hubcap on a busy highway. Idiot."

[HOWDY69]

I washed it ...in the rain. It was sooooo dirty and the rain helped keep ithe dirty soapy stuff wet so I could rinse it off. I just put on my foul weather gear and went at it. It is much happier now.

[1971ford]

Drove it.
zoooooooooooooooooom shift zoooooooooooooooooooom shift zoooooooooooooom!

[dantheman71]

Finally started my 22 gallon Mustang tank install so that I can go for a nice long cruise someday

[Tim P.]

Installed a new chrome sport bumper in the rear with new brackets and the steps from a 65/66 fairlane wagon NIB bty removed the super dupper C/S heavy arse bumper took over 100lbs off the back end man that was one heavy bumper whew!