Cutting the Floor Hump

FloridaPhil · Post by **FloridaPhil** » Sat Jun 09, 2012 12:12 pm

My 1968 Ford F100 Ranger came with a low hump with no hole in the floor. I have a bolt-on high hump from a parts truck and want to cut the floor hole as close to stock as possible. There is a grove in the floor around the spot that needs to be cut out. Anyone have a picture of a stock cut out floor so I can see where they cut it?

basketcase0302 · Post by **basketcase0302** » Sat Jun 09, 2012 12:46 pm

FloridaPhil · Post by **FloridaPhil** » Sat Jun 09, 2012 3:20 pm

Thanks!

basketcase0302 · Post by **basketcase0302** » Sat Jun 09, 2012 6:03 pm

Your quite welcome. And i found an even better one of when I sealed it down:

FloridaPhil · Post by **FloridaPhil** » Sun Jun 10, 2012 5:35 am

Thanks for the pic. I'm glad I saw the clips. That's a lot easier than getting the wife to tighten the bolts while I'm under the truck. :>)

The FORDification.com Forums

Cutting the Floor Hump

Cutting the Floor Hump

Re: Cutting the Floor Hump

Re: Cutting the Floor Hump

Re: Cutting the Floor Hump

Re: Cutting the Floor Hump